Dimensions; Transformers; Accessories; Installation - Honeywell M9484 Manual

AUXILIARY SWITCH RATINGS (amperes):
ONE CONTACT a
Full Load
Locked Rotor
DIMENSIONS: See Fig. 1.
UNDERWRITERS LABORATORIES INC. LISTED
File No. E4436; Guide No. XAPX.
CANADIAN STANDARDS ASSOCIATION CERTIFIED:
General Listing File No. LR1620,400-E-)
STROKE STROKE RUNNING BREAKAWtY
15 set 30 set
30 set 1 min
1.2 min 1 2,4 minD 1 300 134.01 1 600 168.01
overcome occasional large loads such as a seized
damper or valve. MOTOR MUST NOT BE USED
CONTINUOUSLY AT THIS RATING.

ACCESSORIES:

ES6501 17 Explosion-proof Housing-Encloses motor
for use in explosive atmospheres. Not for use with
son Electric Co. Requires Honeywell 7617DM Cou-
pling.
Q607 External Auxiliary Switch-Controls auxiliary
equipment as a function of motor position.
Q605 Damper Linkage-Connects motor to damper.
INCLUDES MOTOR CRANK ARM.
0618 Linkage-Connects Modutrol motor to water or
steam valve.
Q601 Bracket and Linkage Assembly-Connects
Modutrol motor to water or steam valve.
WHEN INSTALLING THIS PRODUCT...
1. Read these instructions carefully. Failure to follow
them could damage the product or cause a hazardous
condition.
2. Checkthe ratings given in the instructions andon the
product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product
operation as provided in these instructions.
120v 240v
7.2 3.6
43.2 21.6
75 18.51 150 [17.0]
150 [17.0] 300 [34.0]
terfly valve. Requires adapter bracket packed with
motor.
motor.
Q68 Dual Control Potentiometer-Controls 1 through 9
additional motors.
Q181 Auxiliary Potentiometer-Controls 1 or 2 addi-
tional motors.
arm. Approximately 0.75 inches shorter than the
4074ELY crank arm, can rotate through downward
position and clear base of motor without requiring
use of adapter bracket.
220741A Screw Terminal Adapter-converts the stan-
dard quick-connect terminals to screws terminals.
Transformers-mounted internally, provide 24 Vat
power to motor
lation).
ranges (4-7 Vdc, 6-9 Vdc, and 10.5-13.5 Vdc).
Adapts motor to M71 XX function.
rent control, with adjustable null and span. Adapts
motor to M72XX function; 4 to 20 mA or 2 to 10 Vdc.
plications. Adapts motor to M73XX function.
with minimum position capability. Adapts motor to
from one Series 90 controller.
Single-zone Logic Panel or W7100 Discharge Air
Controller.
Controller.
in wiring box of M9lXX motor. Can be used in place
of 4074BYK, EAU, EDC, or EED resistor kits (func-
tions described above).
7616ADW Motor Crank Arm-Approximately 0.75
inches shorter than the 7616BR crank arm, can
rotate through the downward position and clear
base of motor without requiring use of adapter
bracket.
Disconnect power supply before beginning in-
1.
stallation to prevent eiectrical shock and equip-
ment damage.
2. Never turn the motor shaft by hand or with a
wrench-this will damage the motor.
3. Always conduct a thorough checkout when in-
stallation is complete.
3
63-2195-l