Getting Started - Siemens DPU User Manual

CHAPTER 1 |

Getting Started

DEVICE PROGRAMMING UNIT USER'S MANUAL
the user will be presented with the display "BATTERY
POWER LOW PLUG IN CHARGER" . This display will be
presented to the user until the charger is plugged in or the
batteries are replaced.
Do not apply physical shock to batteries.
Do not use old and new, chargeable and
unchargeable, charged and uncharged batteries or
batteries of different capacities/kinds/brands mixed
together.
When charging NiMH batteries, charge all six batter-
ies at the same time.
Charge NiMH batteries before using them for the
first time or after not using them for a long time.
Do not load the batteries in the opposite direction to
that shown in these instructions.
There are just a few steps that are necessary before you
are ready to start programming devices and detectors
using the DPU.
• Remove the battery separator strip before using the
DPU by pulling the strip down and out of the
battery compartment.
• If the DPU is to be operated from batteries, make
certain that six charged AA batteries are inserted
correctly in the battery compartment.
• If the DPU is to be operated from AC, connect the
external power supply to the connector provided on
the DPU and then connect it to the wall outlet.
INTRODUCTION
5