Table of Contents
Advertisement
DEVICE PROGRAMMING UNIT USER'S MANUAL
Automatic Printing
Bulk Printing
40
PRINTING LABELS
In order to make the DPU print labels each time a device
is programmed, follow the procedure below.
1.
Connect the DPU to the optional printer with
programming cable P/N 555-134217 . (Refer to Figure
1, page 2, for the location of the printer port.)
2.
With the Main Menu appearing on the display,
press SETUP , then PRINTER and then COPIES. The
display will appear as below:
# OF COPIES=2
<EXIT
3.
Use the INC # and DEC # buttons to set the
number of copies desired. Press EXIT three times
to return to the Main Menu display.
If the printer does not work, turn off the DPU, wait a few
seconds, and then turn it back on and try again.
From one to nine copies of each label may be printed for
a range of addresses by using the bulk print facility.
Following is the procedure:
1.
Connect the DPU to the optional printer with
programming cable P/N 600-190704. (Refer to
Figure 1, page 2, for the location of the printer port.)
2.
With the DPU displaying the Main Menu, press
SETUP , then PRINTER and then BULK. The DPU will
display a screen similar to the following:
S'ADD=123 E'ADD=123
LOOP=111 COPIES=2
<LEFT
<EXIT
|
INC #>
DEC #>
RIGHT>
PRINT>
CHAPTER 4
Hide quick links:
Advertisement
Table of Contents
