Firefinder-Xls / Fs-250 / Fc20 (Fc2025, Fc2050, Fc2005, Fc922, Fc924, Fc901) - Siemens DPU User Manual

DEVICE PROGRAMMING UNIT USER'S MANUAL
FIREFINDER-XLS / FS-250 / FC20 (FC2025, FC2050, FC2005, FC922, FC924,
FC901)
32
TESTING
At the Main Menu press TEST then press MANUAL. The
DPU will prompt for a device to be connected or a
detector to be inserted. (Refer to Figure 2, pages 10-11,
to install devices for testing.) When the device or
detector is found, the display will show the type of device
that has been found, the device address and the current
status of the device as shown in the screen below. The
manual test screen is updated once per second.
HFP-11
ADDRESS=002
NORMAL
<EXIT
HFP-11 Example
Pressing EXIT will return the DPU to the device test
screen. Pressing NEXT will display further screens of
information that will vary depending on the type of device
being tested. Some example screens are shown below:
S/N=94D1F724
USAGE=ALARM
ASD=OFFICE
<EXIT
HFP-11 Example
IEC=CLEAN
TEMP=23C/74F
SENS=3.14%/FT
<EXIT
HFP-11 Example
S/N=04080036
USAGE1=TROUBLE, N/C
USAGE2=ALARM, N/O
<EXIT
HTRI-D Example
|
NEXT>
NEXT>
NEXT>
NEXT>
CHAPTER 3