Kohler Sterling 7110 Series Installation Manual page 14

Nailing
Flange
9. Secure the Wall Surrounds
Attach the end wall to the back wall by engaging the wall interlocks and wall tabs.
Remove the temporary nail at the top of the back wall flange.
CAUTION: Risk of property damage. Wall surrounds must rest within 1/32" (1 mm) (the thickness of
a credit card) from the bath to ensure proper water management and to prevent leakage.
Check to be sure all walls are seated firmly on the bath and that the back wall interlocks are
engaged.
Verify that the front edges of the end walls are flush with the front edge of the bath.
If a gap exists, pull the end walls slightly forward to eliminate the gap.
CAUTION: Risk of product or property damage. If using screws rather than nails, do not overtighten
the screws. Excessive tightening can damage the flange.
Use large head roofing nails or flat head screws at the dimples on the nailing flange in order to
secure the wall surrounds to the studs. Secure both end walls first starting at the bottom and
moving up the sides.
Secure the flanges across the top of the wall panels at every stud location.
Finish the Installation of the Wall Surround
NOTE: A gap between the edge of the wall surround and the finished wall, when sealed, helps to reduce
the possibility of water seeping into the wall material. Apply the water-resistant wall material over the
nailing-in flanges leaving a 1/8" (3 mm) gap between the wall surround and the wall material.
Cover the framing around the wall surrounds and the shower bath with water-resistant wall
material.
Seal the joints between the bath and the finished wall material with silicone sealant. Allow the
sealant to cure according to the manufacturer's instructions.
1021859-2-E
Wall Surround
Credit Card
Bath Rim
Shim if
necessary.
Roofing Nail
or Screw
14
Roofing Nail
or Screw
Sterling