Memory Storage - Clarity C4105 User Manual

Pause Feature
Programming in a pause will cause the phone to wait four (4) seconds before
dialing additional numbers.This feature may be used when it is necessary to dial
an access code (9, for example) and wait for a second dial tone before you can
dial an outside number. Press the RD/P button at the required point during the
memory storage process to program a pause.
Temporary Tone
If you have rotary (pulse) dial service, you can change from pulse to touch tone
(tone) during a call.
1. Make phone call and wait until it is connected.
2. Press the * key. Keys pressed after this are sent as tone signals.
3. The phone will automatically reset to pulse service after the call ends.
Lighted Key Pad
The key pad will light for fifteen (15) seconds after removing the handset from
the base.To reactivate the feature while in standby, press the TALK or the MEM
button.To activate while the phone is in use, press any key.
Page/Handset Locator
To send a page signal from the base to the handset, press the PAGE button
located on the base of the telephone.A series of rings will sound from the
handset.
To locate the handset if it is away from the base, press and hold the PAGE but-
ton for approximately five (5) seconds.A series of rings will sound. Return the
handset to the base or press any button to cancel the page.
Channel Operation
The C4105 cordless telephone automatically searches and selects the clearest
of 40 channels when it is being used. If interference develops on the line, press-
ing this button will move to another channel.
Security Code
The security code prevents your cordless phone conversations from being ac-
cessed by a phone on a different line. Once the handset battery is fully charged,
the handset will automatically select the code from over 65,000 different com-
binations.The code is changed every time the handset is placed in the cradle. If
18
you have trouble with placing or receiving calls, a lost security code may be the
cause of the problem.When this occurs, the handset can no longer communi-
cate with the base.

MEMORY STORAGE

The C4105 has ten (10) indirect, or two touch, memory storage locations on
the telephone handset (0-9) that can be programmed to dial frequently called
numbers of up to 16 digits.
Adding a Memory Location
1. Unit must be in standby mode only.
2. Press the MEM button.
3. Enter the telephone number you wish to store.
4. Press the MEM button.
5. Press the number on the dial pad that you wish to store the number to.
6. A long beep will indicate the programming process is complete.
During the memory storage process the TALK button will flash GREEN.
Use the RD/P button while entering the telephone number to insert a pause.
Refer to the Pause Feature section on page 21.
Dialing a Memory Location
1. Press the TALK button.
2. Press the MEM button.
3. Press the number on the dial pad for the stored number you wish to call.
4. The call will automatically dial.
Adding an EMERGENCY Number
1. Unit must be in standby mode only.
2. Press the MEM button.
3. Enter the telephone number you wish to store.
4. Press the MEM button.
5. Press the emergency button on the dial pad that you wish to store the
number to.
6. A long beep will indicate the programming process is complete.
19