Table of Contents
Advertisement
I I m m p p o o r r t t a a n n t t ! ! To achieve the best possible range, DO NOT leave the antenna cable bundled
under the dash. Always extend the cable full length during installation, regardless of the
antenna mounting location.
shock sensor harness, 4-pin WHITE plug
GREEN (-) Multiplex Input
Inputs shorter than 0.8 seconds will trigger the Warning response, while inputs longer than 0.8 sec-
onds will trigger full alarm sequence and report Zone 4.
N N O O T T E E : : If installing an optional dual-stage sensor, connect to the GREEN wire. The following diagram elim-
inates the need for diodes to isolate the sensors, as well as providing a separate zone for each sensor.
Diagram for adding optional dual stage sensor to GREEN wire (zone 4).
BLUE WIRE OF
PRE-WIRED PLUG
GREEN WIRE OF
PRE-WIRED PLUG
BLUE (-) Multiplex Input
Inputs shorter than 0.8 seconds will trigger the Warn Away® response, while inputs longer than 0.8
seconds will trigger full alarm sequence and report Zone 2.
RED (+) 12V Constant and BLACK (-) Ground
Do not use these for anything besides the plug-in shock sensor.
BLUE WIRE FROM PLUG-IN
CUT
X
X
PLUG-IN SHOCK SENSOR
SHOCK SENSOR
GREEN WIRE FROM
BLUE AND GREEN WIRES
FROM DUAL STAGE SENSOR
23
Advertisement
Table of Contents
