4.3
Paper Feed Troubleshooting
Problem
Paper doesn't feed.
Paper is skew.
Paper doesn't align with
print position.
• Paper path is wrong.
• Mechanism head is open.
• Paper end is not in contact
with the paper guide.
• Roll guide is not in contact
with the roll paper.
• Head pressure is not proper.
• Setting mode is not proper.
• Paper gap (black line) sensor
adjustment failure.
• Transfer data is abnormal.
4-8
Cause and remedy
→
Use the proper path.
→
Close the mechanism head.
→
Slightly push the paper
guide against the paper end.
→
Slightly push the roll guide
against the roll paper.
→
Adjust it with the offset
adjust-screw according to
the width of the paper.
→
Check whether the setting
mode is the paper gap or
black line detection and if it
is not proper, change it.
→
Adjust the voltage of the
paper gap and black line
sensor in the system
maintenance mode.
→
If the contents of the
transfer data are not set
properly, set them again.