Toyota Yaris Owner's Manual page 116

z Do not continue hill climbing or
hard towing for a long time in the
"2" or "L" position. This may cause
severe automatic transmission dam-
age from overheating. To prevent
such damage, "D" or "3" position
should be used in hill climbing or
hard towing.
(e) Backing up
1. Bring the vehicle to a complete stop.
2. With the brake pedal held down with
your foot, shift the selector lever to the
"R" position.
NOTICE
Never shift into reverse while the ve-
hicle is moving.
(f) Parking
1. Bring the vehicle to a complete stop.
2. Pull the parking brake lever up fully to
securely apply the parking brake.
3. With the brake pedal pressed down,
shift the selector lever to the "P" posi-
tion.
CAUTION
Never attempt to move the selector
lever into "P" position under any cir-
cumstances while the vehicle is mov-
ing. Serious mechanical damage and
loss of vehicle control may result.
(g) Good driving practice
If the transmission repeatedly shifts up
D
and down between the third gear and
overdrive gears when climbing a gentle
slope, shift the selector lever to the "3"
position. Be sure to shift the selector
lever to the "D" position immediately
afterward.
When towing a trailer, in order to main-
D
tain engine braking efficiency, do not
use "D" position. The selector lever
must be in the "3" position.
CAUTION
Always keep your foot on the brake
pedal while stopped with the engine
running. This prevents the vehicle
from creeping.
NOTICE
Always use the brake pedal or the
parking brake to hold the vehicle on
an upgrade. Do not attempt to hold
the vehicle using the accelerator ped-
al, as this can cause the transmission
to overheat.
(h) If you cannot move the selector le-
ver out of "P" position
If you cannot shift the selector lever from
the "P" position even though the brake
pedal is depressed, use the shift lock
override button, For instructions, see "If
you cannot shift automatic transmission
selector lever" on page 191 in Section 4.
109