Selecting A Pre-Configured Preparation Time; Setting A Start Time Delay; Prematurely Terminating The Current Preparation Step - Bosch MUC 2 RU Series Instruction Manual

en Operation
[ подогрев ] (keep warm) light up. A
rectangle lights up in the display (dotted
lines). The keep warm function can be
ended using button H. The appliance
subsequently switches to function
selection mode.
If the selected preparation programme
consists of multiple preparation steps, an
audible signal sounds once the next step
needs to take place. In the control panel,
LEDs 1, 2, 3 or 4 are shown accordingly
and button G flashes. Perform the
following steps:
1� Open the lid of the appliance.
2� Add additional ingredients.
3� Close the lid of the appliance.
4� Start the next preparation step using
button G.
The appliance heats up the appliance
interior until the target temperature of the
next preparation step is reached. During
the heating phase, lines that light up in a
clockwise direction appear in the display.
Once the target temperature is reached, the
lines go out and the next preparation time
is shown in the display. The preparation
process starts automatically. The prepara-
tion time counts down.
Selecting a pre-configured
preparation time
The pre-configured preparation time of
the level [ средняя ] (medium) is shown
on the control panel for each preparation
programme.
The preparation time can be shortened
[ короткая ] or lengthened [ длинная ].
1� Keep pressing button E until the
desired indicator is lit. The display
changes from [ средняя ] (medium)
to [ длинная ] (longer) and then to
[ короткая ] (shorter) before returning to
[ средняя ] (medium).
The corresponding pre-configured values
for the preparation time are shown in the
display.
12
MUC_2-4_RU_8001013355.indb 12
2� Press button G to start the preparation
programme.
X "Selecting and starting a preparation
programme" see page 10

Setting a start time delay

The start time delay can be set for the
selected preparation programme so you
can enjoy a freshly prepared meal at a
specific time.
Note: the start time delay can only be
set for certain preparation programmes.
The pre-configured start time delay varies
among these preparation programmes.
1� Select the preparation programme.
2� Press button A. Button G flashes.
"00:10" flashes in the display.
Press button A repeatedly to increase the
displayed time. A brief press increases the
time by 5 minutes. A slightly longer press
increases the time by 10 minutes. Pressing
and holding button A for around 2 seconds
increases the time by 30 minutes.
3� Press button G when the desired start
time delay is displayed.
The desired start time delay is shown in the
display. [ таймер ] (timer) lights up in the
display.
The time until the start counts down. Once
this time has elapsed, the preparation
process starts automatically.
Notes:
■ The start time delay can be switched
off at any time by pressing button G.
The preparation programme then starts
immediately.
■ If "00:10" does not flash in the display, a
start time display cannot be set for the
selected preparation programme.
Prematurely terminating the
current preparation step
If the ingredients are cooked ahead of time
during one of the preparation steps, the
step can also be terminated manually.
10.08.2015 12:44:52