Kohler KD83V16 Service And Repair Manual page 250

Repair
Electrical system
u Remove screws 4.
u Remove starter 2.
Installation
u Position starter 2.
u Tighten screws 4.
u Connect plug 3.
u Connect power supply 5 with nut.
u Tighten nut to torque.
u Connect ground cable 6 with nut and tighten according to tightening specifications.
Specific values
Not applicable.
Tightening specifications
Fig. 286: Starter nuts
1 -
2 -
Tab. 55: Tightening specifications table
*Lubricants:
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
O = Engine oil
250
Key Screw specifications
M12
M12
© 2021 by Kohler Co. All rights reserved.
Service and Repair Manual
Torque
± 5%
- Yes 1 22 Nm
(16 ft-lb)-
30 Nm
(22 ft-lb)
- Yes 1 22 Nm
(16 ft-lb)-
30 Nm
(22 ft-lb)
KD83V16 33525088901_2_1 EN_US
Angle (°)
± 5°
- -
- -
2021-07