Kohler KD83V16 Service And Repair Manual page 218

Repair
Cooling system
Tightening specifications
Fig. 247: Clamp screws
1 383AA
Tab. 45: Tightening specifications table
*Lubricants:
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
O = Engine oil
XX = Loctite 243
YY = Loctite 577
**Refer to screws reuse rules.
marking, page 274.)
Turbocharger cooling lines removal and installation (EATS config-
uration)
Previous tasks
q Remove venting lines.
page 205.)
218
Key Screw specifications
ISO 4014 M10x1.5x60-8.8-FLZN
(For more information see: 5.3.2 Screws pre-tightening, reuse and
(For more information see: 3.10.2 Venting line removal and installation,
© 2021 by Kohler Co. All rights reserved.
Service and Repair Manual
Torque
± 5%
- Yes 1 30 Nm
22 ft-lb
KD83V16 33525088901_2_1 EN_US
Angle (°)
± 5°
- -
2021-07