Operation; Powering On; License Agreement; Welding / Cutting Selection Screen - Lincoln Electric VRTEX 360 COMPACT Operator's Manual

VRTEX 360 COMPACT
®

POWERING ON

* Ensure coupon arm cable and intended welding devices are
connected before turning on the machine.
1. Pressing the power button on the front of the machine powers
up the VRTEX system. See Figure 28.
NOTE: Select Log Out and Shutdown from the red menu icon to turn
off the system. Pressing the power button will also shutdown
the system.
Figure 28 – Power button
NOTE: Main power disconnect located in the rear of the machine.

LICENSE AGREEMENT

The License Agreement is an agreement to the terms and conditions
on which Lincoln Electric grants to the business entity registered
with Lincoln on the purchase of the Software ("Software Licensee"),
a non-exclusive license to use the Software and Documentation
accompanying this license on the VRTEX Virtual Reality Welding
Trainer. The license granted herein is strictly limited to the installation
of said Software on the VRTEX Virtual Reality Welding Trainer that the
Licensee has properly registered with Lincoln.
This is the first screen that will appear once the Software upgrade has
been accomplished. In past upgrades the system would move directly
into the License page of the Instructors mode. This upgrade the user
must agree to the terms and conditions before moving forward.
SELECTING AGREE OR DO NOT AGREE
Once the user has completely read the EULA select the "I have read
the EULA and agreed to its terms" and move forward or select "I do
not agree" which will turn off the machine. Selecting the "I have read
the EULA and agreed to its terms" will take the user to the "License"
screen.
NOTE: The user cannot continue on the VRTEX until they AGREE to the
License Agreement.
Figure 29 – End user license agreement (EULA)
WELDING / CUTTING
SELECTION SCREEN
Welding and cutting are available with the VRTEX. The user can
select either at startup. To enable Cutting contact a Lincoln Electric
representation.
Figure 30 – Welding / cutting selection screen
17

OPERATION

Select the icon
to choose "I
have read the
EULA and
agree to its
terms."