User Mode; Login Screen - Lincoln Electric VRTEX 360 COMPACT Operator's Manual

VRTEX 360 COMPACT
®

USER MODE

SYSTEM SETUP INFORMATION
When setting up the virtual equipment, the user must set the welding
parameters (e.g. wire feed speed for VR GMAW) within the ranges
set in the tolerance editor. The system ships with Lincoln default
tolerances. Lincoln default tolerances can be reviewed in the
tolerance editor or in the WPS manual.
However, instructors can set and use their own tolerances and control
limits for teaching welders. The tolerances also determine how the
user is scored on such parameters as work angle, travel angle, travel
speed, position and contact tip to work distance or arc length. See
the Tolerance Editor section for more details.
MEASUREMENT UNITS
Coupon Thickness
Gas Flow Rate
Wire Feed Speed
Weldometer - Base Metal
Weldometer - Gas
Weldometer - Consumables
OVERVIEW
This page allows the user to: (See Figure 31)
• Enter Username
• Select Language Preference (Orange Icon)
• Select Imperial or Metric Units (Blue Icon) - See Table 1 for details
• Shutdown System (Red Icon)
• Continue to the next Setup Screen (Green Icon)
• Select Theory (Yellow Icon)
Table 1 – Measurement units
Imperial
Abbrev. Details
in. inches
CFM cubic feet per minute
IPM inches per minute
lbs pounds
CF cubic feet
lbs pounds
18
OPERATION (USER MODE)

LOGIN SCREEN

Figure 31 – Login screen
Metric
Abbrev.
mm millimeters
LPM liters per minute
MPM meters per minute
kg kilograms
L liters
kg kilograms
Details