4
In the Choose protocol dialog box, touch the same protocol selected for the IPWedge computer application.
(TCP is the default).
Figure 4-9 Protocol Selection
Touch IP Address.
5
6
In the Enter IP Address dialog box, enter the IP address of host computer to send data to.
Figure 4-10 IP Address Entry
7
Touch Port.
8
In the Enter port number dialog box, enter same port number selected for IPWedge computer application.
Figure 4-11 Port Number Entry
Configure Advanced data formatting and Basic data formatting Plug-in if any required modification to be
9
done to captured data before sending to remote computer.
MN000112A01 - September 2013
4.6.5.1 Using IP Output with IPWedge
4-23