SECTION 7 - HYDRAULICS
Figure 7-12. Motor Brushes
3.
Remove the protection cover from the motor (1).
4.
Remove the brush terminal screw (2).
5.
Lift the spiral spring (3) and remove the brush (4)
from its housing.
6.
Repeat previous steps for each brush (Qty: 4).
Brushes Installation:
1.
Lift the spiral spring (3) and slide the brush (4) into
its housing.
2.
Attach the brush terminal end to the terminal post
using the terminal screw (2).
3.
Repeat previous steps for each brush.
4.
Install the protection cover (1).
5.
Secure the hydraulic power unit to the machine, as
originally installed.
6.
Connect battery plug and check for proper opera-
tion of the machine.
7-6
7.4 SWING MOTOR
NOTE: Refer to Section 5 of this manual for swing motor
removal procedure.
Figure 7-13. Swing Motors
Ports Identification
Toucan 8E/Toucan 20E
Port 1: Swing Right
Port 2: Swing Left
Toucan 10E/Toucan 26E
Port A: Swing Left
Port B: Swing Right
Port DR: Drain Port - Plugged
– JLG Lift –
31210090