Lubrication Chart - JLG TOUCAN 8E Service And Maintenance Manual

Lubrication Chart

1. Swing bearing race
2. Swing bearing Teeth
3. Mast profiles
Component
1 Swing Bearing Race
2 Swing Bearing Teeth
3 Mast Profiles
4 Lifting Chains
5 Hydraulic Oil
6 Overload System Spring Washers
7 Hydraulic Filter
NOTE: Lubrication intervals are based on machine operation under normal condition. For machines used in multi shift opera-
tions and/or exposed to hostile environments or conditions, lubrication frequencies must be increased accordingly.
NOTE: Refer to the corresponding sections in this manual for specific lubrication procedures.
31210090
4. Lifting Chains
5. Hydraulic Oil
Figure 1-1. Lubrication Chart
Table 1-13. Lubrication Chart
Number/Type
Lube
Lube Points
2 grease fittings A
By brush B
By brush A
Spray on or by
C
brush
Fill through
D
reservoir cap
By brush E
N/A N/A
– JLG Lift –
SECTION 1 - OPERATING SPECIFICATIONS
6.
7.
Interval Hours
125 250 1000
X
X Remove old grease first
X Remove old grease first
X Lubricate before first 50 hours of operation
X Check level daily. Change at least every 2 years
X
X Change after first 50 hours of operation
Overload System Spring
Washers
Hydraulic Filter
Comments
1-7