Table of Contents
Advertisement
1.1.Procedures of installation
(Please thoroughly observe these recommendations) 3
Operation check before installation
Confirm if each display can operate properly prior to the video wall installation.
confirmed after installation, the labor and time detaching are required.
Carry out the operation check before installation.
A protective film is attached on the display. Remove it before confirming
operation. After the check, it is recommended to reattach the film
until just before the completion of installation to protect the display.
Ref. You can check the PN-V701's panel status (color, brightness, damage, or existence or nonexistence of
bright point/black point, light leakage, floating) in accordance with the following procedure.
Note that you can't check all the features of PN-V701 with the following procedure.
When using remote controller
1. Press the [SIZE] button (over 5 sec.) and "F" is
displayed at the upper left of screen.
2. Press the [
] [
] [
3. The screen display changes in the following sequence,
each time you press the [
Black, Dark Blue, Dark Green, Dark Red,
Blue, Green, Red, White, Gray1, Gray2.
4. Turn off the power after checking the display.
Confidential
] [
] buttons.
] button.
Copyright © All rights reserved, SHARP CORPORATION
When using key on the rear panel
1. Press the "MENU" and "INPUT" keys (over 5 sec.)
and "F" is displayed at the upper left of screen.
2 Press the [
] [
] [
3. The screen display changes in the following sequence,
each time you press the [
Black, Dark Blue, Dark Green, Dark Red,
Blue, Green, Red, White, Gray1, Gray2.
4. Turn off the power after checking the display.
If a failure is
Protective
film
Corner protective
Tape
materials
] [
] buttons.
] button.
5
Advertisement
Table of Contents
