Hoover Nextra HNF 6137 Instruction Book page 33

40003219Eng.qxd 24/06/2005
Water on the floor around the washing machine...
● Is the fill hose tightened? If so, replace the rubber washers and re-tighten.
● Is the standpipe or the household drain blocked? If so, clear the blockage
yourself or call a plumber.
● Is there clothing or dirt between the door gasket and the door glass?
Ensure that the door glass and gasket are kept clean and free of laundry
when loading the machine.
The machine does not spin...
●
Water has not drained from the machine? Check the points highlighted
above.
●
Have you selected an option that changes the spin profile (
of spin speed on the selector)? Check the feature in the description of
the controls.
● Is the load unbalanced? To reduce noise and vibration and improve the
machine's reliability and life, the machine is fitted with an electronic
sensor that detects if the load is unbalanced. To improve the spin
performance the load can be re-distributed by hand at the end of the
cycle and then re-spun.
The machine is noisy or vibrates a lot during the cycle...
●
Has the transit system been fully removed? Check that the bracket and
the polystyrene packing have been taken off the machine.
● Are there any loose items in the pockets of clothing that can rattle in the
drum and cause damage?
● Is the load unbalanced? Stop the programme, re-distribute the load and
restart.
The programme takes a long time...
● Some programmes do take a long time (over 2 hours). Low water
pressure can increase the length of the programme.
The door will not open...
● Has the programme finished?
Is the STOP light illuminated? If not the programme is not complete.
Has the
the light will go out and you will be able to open the door.
● Has the programme finished but the door remains locked? The START and
light will flash intermittently indicating that the water supply has
been interrupted during the wash cycle. Turn the machine to OFF to reset
the machine and this will allow the door to open.
19:22 Page 33
light gone out? If not wait a further couple of minutes and
or change
33