How To Adjust The Handle - Chicco KEYFIT Instructions Manual

ness into the anchor-shaped hook (diag.
9).
Storing the Product
When it is not fi tted into the car, it is rec-
ommended to store the child car seat in a
dry place, away from sources of heat and to
protect it from dust, humidity and direct sun-
light.
HOW TO FIT THE CHILD CAR SEAT INTO
THE CAR
5. Put the child car seat's handle in a vertical
position, pressing the two side adjustment
buttons (diag. 10).
6. Place the child car seat onto the car seat
where you wish to fi t it (diag. 11).
7. Pull the car safety belt and lock it into the
appropriate buckle, sliding the lap belt into
the two side guides of the child car seat
(diag. 12).
8. Hold the diagonal belt and pull it, until the
lap belt is tensioned correctly (diag. 13). At
the end of these operations, check that the
lap belt is still locked correctly into the ap-
propriate guides.
9. While keeping the diagonal belt tensioned,
slide it into the guide, located on the rear
of the backseat (diag. 14). Tension the belt
as much as possible, checking that it is not
slack or twisted.
WARNING! After fi tting the child car seat,
always check that car safety belt is tensioned
correctly, and that it is safely locked into its
buckle. Also check that the buckle of the car
safety belt does not come into contact with
the points where the safety belt fastens the
child car seat: it could make the child car seat
unsafe in the event of an accident (diag. 15A,
diag. 15B)
CAUTION! For your child's safety: Do not fa-
sten the child car seat with the car safety belt
in any other ways than as indicated in this in-
structions booklet!
HOW TO PLACE THE CHILD INTO THE CHI-
LD CAR SEAT
10. Press the orange button located at the front
of the child car seat and, while pressing the
button, pull completely the two belts of the
child car seat (diag. 16).
11. Unfasten the buckle of the safety belts
pressing the red button (diag. 17).
12. Place the child into the child car seat and
fasten the harness (diag. 18). The shape of
the straps does not allow to insert a single
strap.
13. Tension the safety harness, pulling the ap-
propriate adjustment belt (diag. 19), and
make sure that it fi ts correctly the child

HOW TO ADJUST THE HANDLE

The handle of the child car seat can be ad-
justed to 3 positions (diag. 20):
A Position for car, hand or stroller transporta-
tion.
B Rocking position.
C Baby chair position.
CHILD CAR SEAT IN THE BOUNCING OR
BABY CHAIR POSITION
1. Unfasten the car safety belt.
2. Remove the diagonal part of the car safety
belt form the clamp.
3. Hold the safety belt and ease it into the
retractor.
How to Fit the Child Car Seat into the Car
without the Child
When it is not used in the car, the child car
seat can also be used as a bouncing or baby
chair.
To use it in the rocking position, place the han-
dle in the "B" position.
To use it as a baby chair, place the handle in
the "C" position.
The use of the child car seat as a bouncing
chair is not recommended for children who
are able to stand up independently (approxi-
mately up to 6 months of age, or 9 Kg. of
weight).
To avoid the risk of falls, the child must always
be fastened in.
WARNING! Never leave your child unat-
tended.
WARNING! It is dangerous to use the child car
seat on high or sloped surfaces.
29