Furuno M12-05BM+05BF-010 Design Manual page 9

(b) GP-330B
The supplied contact pin, 05-251-01 (C/N: 000-168-935) is inserted into socket #5 in the
connector before connecting it to the antenna.
(c) WS-200
The same contact pin as GP-330B is used for termination. (Type: 05-251-01)
(d) SC-30
Use the cable, MJ-A10SPF0015-15/30 of which 10-pin MJ connector has a 120-ohm
resistor connected between pins #4 and #5.
120-ohm resistor
(e) FI-50
The terminal resistor is on and off through "Setup2" menu. To show setup2 menu, press
following two keys at a time until the menu appears.
FI-50 series
FI-501/502/505
FI-503
FI-504
FI-506
Contact pin
Fig.27 Termination on GP-330B
>1>
>2>
>3>
>4>
>5>
>6>
>7>
>8>
>9>
>10>
Fig.28 Termination on SC-30
To get into Setup2 mode, press
3rd and 4th keys from left
LOWER and SELECT/CLEAR
APP/TRUE and SELECT/CLEAR
BRILL and Left arrow key
(To save the change, press BRILL
and Left arrow key again.)
Furuno CAN bus Network Design Guide
Drain
RED
BLK
WHT
BLU
MJ-A10SPF0015
PPL
YEL
GRN
To choose item, press
MODE
Upper
DISP
Right arrow key
9
Connector has
a resistor.