Stihl 064 Service Manual page 38

STIHL 064, 066
Top:
Fitting crankshaft
Bottom:
1 = Threaded sleeve 5910 893 2420
2 = Screw thread on crankshaft stub
- Coat bearing seat of crankshaft
stub at ignition end with oil and
position it in the bearing from the
inside of the crankcase.
- Screw the threaded sleeve onto
the crankshaft stub.
Top.
Screwing service tool into position
Bottom:
Pulling crankshaft into ball bearing
- Hold the service tool and crank-
shaft steady and rotate the
spindle clockwise until the ser-
vice tool butts against the crank-
case.
- Pull the crankshaft into the bear-
ing as far as it will go by turning
the spindle clockwise.
Important: The connecting rod
must point toward the cylinder
flange while the crankshaft is
being installed.
Top
Unscrewing service tool ZS
Bottom:
Fitting crankcase gasket
- Remove the service tool: Re-
lease the spindle by turning it
counterclockwise and then un-
screw the service tool counter-
clockwise.
- Fit a new gasket on the ignition
side of the crankcase.
38