Stihl 064 Service Manual page 71

STIHL 064, 066
Top:
Generator wire in rear grommet (1),
insulating tube (2) and retainer (3)
Center:
Centering tool 1118 893 3500 in
position
Bottom:
Removing centering tool with
puller 1107 890 4500
Installing the generator:
- On 066, slip the insulating tube over the
generator connecting wire, slide the pin
housing onto the terminal pin until it
engages and then push the male connector
into the female connector.
Note: Installation of the generator is the
same as for the 064. Fitting the electrical
wires, as described below, is only necessary
on the 064.
- Thread the generator wire through the
retainer, the insulating tube and the rear
grommet.
- Place generator in position on the three
mounting bosses.
- Coat threads of mounting screws with
Loctite, see 12.2, fit them in the generator
and tighten down moderately.
- Fit the centering tool on the crankshaft so
that its groove engages the Woodruff key.
- Finally tighten the three mounting screws
to a torque load of 2 Nm (1.5 Ibf.ft).
- Remove the centering tool. If. necessary,
use puller to remove the centering tool from
the crankshaft.
- Push the retainer into the crankcase.
Note: The generator connecting wire must
be positioned in the crankcase recess and
below the mounting boss for the upper ignition
module screw.
Top:
Position of generator connecting
wire in crankcase recess and below
upper ignition module mounting boss
1 = Seat of retainer in crankcase
Bottom:
Position of generator connecting
wire below fuel line and below the
throttle rod
On the 066, the insulating tube must butt
against the crankcase recess
Assembly is now a reversal of the
disassembly sequence.
Make sure the generator connecting wire is
located below the fuel line and below the
throttle rod.
71