Chapter 13 Data Communications; Connecting Two Units; Connecting The Calculator To A Personal Computer - Casio fx-9750GII User Manual

Chapter 13
This chapter tells you everything you need to know to transfer programs between two
CASIO Power Graphic calculators connected using the cable that is equipped as a standard
accessory.

1. Connecting Two Units

The following procedure describes how to connect two units with the connecting cable that
comes equipped as a standard accessory.
To connect two units
1. Check to make sure that the power of both units is off.
2. Connect the two units using the cable.
• Step 3 is not required on the fx-7400G
3. Perform the following steps on both units to specify 3PIN as the cable type.
(1) From the Main Menu, enter the LINK mode.
(2) Press (CABL). This displays the cable type selection screen.
(3) Press (3PIN).
• Models that are supported for this configuration are shown below.
II
fx-9860G SD, fx-9860G
(OS 2.00/1.11), fx-9860G SD (OS 2.00/1.05), fx-9860G (OS 2.00/1.05), fx-9860G AU (OS
2.00/1.05), fx-7400G series, CFX-9850G series
2. Connecting the Calculator to a Personal
Computer
You can transfer data between the calculator and a computer by using the Program-Link
Software (FA-124) and a special cable*
For details about establishing a connection and data transfer procedures, see the FA-124
User's Guide.
Data Communications
II
.
II
, fx-9860G AU PLUS, fx-9750G
1
to establish a connection between them.
Cable
II
, fx-7400G
13-1
II
, fx-9860G Slim
13