Searching For Data Inside A Program - Casio fx-9750GII User Manual

• Error messages appearing when the program is run
• Results that are not within your expectations
To eliminate bugs that cause error messages
An error message, like the one shown to the right, appears
whenever something illegal occurs during program execution.
When such a message appears, press
error was caused. The cursor will be flashing at the location of the problem. Check the "Error
Message Table" (page -1) for steps you should take to correct the situation.
• Note that pressing
protected.
To eliminate bugs that cause bad results
If your program produces results that are not what you normally expect, check the contents of
the program and make necessary changes.
(TOP) ... Moves the cursor to the top of the
(BTM)... Moves the cursor to the bottom of

Searching for Data Inside a Program

Example To search for the letter "A" inside the program named OCTA
1. Recall the program.
2. Press (SRC) and input the data you want to find.
3. Press to begin the search. The contents of the
program appear on the screen with the cursor located at
the first instance of the data you specified.*
does not display the location of the error if the program is password
program
the program
(SRC)
(A)
to display the place in the program where the
1
8-4