Entering The Pattern Data - Brother PC-420 Operation Manual

UTILITY STITCHES ——————————————————————————————————————————————————

Entering the pattern data

Follow the pattern drawn on the grid sheet and
program the pattern into the sewing machine.
1 Attach monogramming foot "N".
• For details, refer to "Replacing the presser
foot" (page 37).
2 Turn on the sewing machine.
3 Press (stitch selection key) in the
operation panel.
The screen containing the various types of
stitches appears.
4 Press , ,
is selected, and then press
key).
The screen for entering a pattern appears.
1
2
1 Number of the current point/Total number of
points
2 Horizontal coordinate (0–75)
3 Vertical coordinate (0–14)
5 Check the grid sheet set, and specify the
coordinates of the first point.
Press and to select the horizontal
coordinate and press
vertical coordinate, and then press
key).
124
and (arrow keys) until
(OK
3
and to select the
(OK
6 Specify the coordinates of the second point,
and then press
A screen appears, allowing you to specify
the settings for the stitching between the
two points.
7 Specify whether single stitching or triple
stitching will be sewn between the points.
Press and to select
stitching or for triple stitching, and then
press (OK key).
A screen for selecting the next operation
appears.
8 Select , and then press
• If you make a mistake while specifying a
point, press the C key to erase the last point
specified.
A screen for specifying the next point
appears.
6
9 Repeat steps through
point.
Up to 99 points can be entered.
0 After all points in the pattern have been
specified, select
8
in step , and then press
(OK key).
for single
(OK key).
8
to specify each
in the screen that appears
(OK key).