Changing The Stitch Density; Changing The Pattern Length - Brother PC-420 Operation Manual

UTILITY STITCHES ——————————————————————————————————————————————————
Changing the stitch
density
If a decorative satin stitch has been selected, the
stitch density can be changed.
1 Select a decorative satin stitch
2 Press (settings key) in the operation panel.
The settings screen appears.
3 Press , ,
is selected.
4 Press (OK key).
The screen for specifying the stitching
density of the decorative satin stitch
appears.
5 Press and until the desired density is
selected.
Select for coarser stitching or select
for finer stitching.
6 Press (OK key).
The initial stitch screen appears again, and
the stitching density is changed.
CAUTION
●
If the stitching density is too fine,
depending on the needle, the stitches
may be bunched together, causing the
needle to break.
118
.
and (arrow keys) until

Changing the pattern length

The length of one part of a satin stitch can be set to
one of five sizes.
1 Select a satin stitch
2 Press (settings key) in the operation panel.
The settings screen appears.
3 Press , ,
is selected.
4 Press (OK key).
The screen for changing the length of a satin
stitch appears.
5 Press and until the desired ratio is
selected.
The length can be set within the range of
and .
The satin stitch length is changed.
6 Press (OK key).
The initial stitch screen appears again.
.
and (arrow keys) until