Table of Contents
Advertisement
Turret Rotation
The turret rotates 360° around the column (see
Figure 19).
Figure 19. Head and turret rotated 45° to the
left.
Tools Needed
Wrench 19mm ................................................... 1
To rotate the turret left or right:
1.
DISCONNECT THE MILL FROM POWER!
Always lock the turret firmly in place after
adjusting the rotation. Unexpected move-
ment of the head during operations could
cause the cutter to bind with the workpiece
causing damage to the cutter and workpiece,
and possible personal injury.
-20-
2.
Loosen the three locking hex nuts on the tur-
ret (see Figure 20).
Figure 20. Turret rotation locking hex nuts (2 of
3.
Rotate the head and turret around the column
to the left or right and use the turret rotation
scale to determine the amount of rotation.
Qty
4.
Re-tighten the three locking hex nuts to
secure the head and turret in place.
Turret Locking Hex Nuts
(2 of 3)
3 shown).
Model G0678 (Mfd. Since 06/15)
Turret
Rotation
Scale
Advertisement
Table of Contents
