Grizzly G0678 Owner's Manual page 29

NOTICE
Follow the lubrication practices outlined in
this manual. Failure to do so could lead to
premature failure of your mill and will void
the warranty.
One-Shot Oiler
Lubricant
ISO 68 Lubricant or
Equivalent
The oil lines running from the one-shot oiler feed
lubrication to the ways of the column (knee),
saddle, and table.
Use the sight glass on the front of the oiler to
make sure it is full, then pull the handle (see
Figure 34) and release it to send the lubricant
through the lines.
Fill Cap
Figure 34. One-shot oiler.
Model G0678 (Mfd. Since 06/15)
Frequency Qty
Every 1
8 Hours Pump
of Operation
Oil Line
One-Shot
Pump
Handle
Quill Gearing
Lubricant
ISO 68 Lubricant or
Equivalent
Lift the cap of the oil cup shown in Figure 35 to
add the lubricant.
Quill Gearing
Oil Cup
Figure 35. Quill gearing oil cup.
Vertical Bevel Gears
Lubricant
NLGI #2 Grease
Raise the knee up to access the vertical bevel
gears underneath the saddle, then clean and
lubricate the bevel gears shown in Figure 36.
Bevel Gears
Figure 36. Vertical bevel gears.
Frequency Qty
Every 5
8 Hours Drops
of Operation
Frequency Qty
Every Thin
40 Hours Coat
of Operation
-27-