Table of Contents
Advertisement
Table Movement
Your mill table has three paths of movement con-
trolled by the corresponding handwheels or crank
(see Figure 12): 1) Longitudinal (X-axis), 2) cross
feed (Y-axis), and 3) vertical (Z-axis).
Logitudinal (X-Axis)
or Left & Right
Vertical (Z-Axis) or
Up & Down
Figure 12. The three movement paths of the mill
table.
The graduated dials are marked in increments
of 0.001", with a full revolution moving the table
0.125".
Locks
Use the table, saddle, and knee locks shown in
Figures 13–14 to secure the table in position.
Table Locks
Figure 13. Table locks.
-18-
Cross Feed
(Y-Axis) or
Limit Stops
In & Out
Position the limit stops along the limit stop tracks
to confine the distance the table or saddle can
travel (see Figures 15–16).
Knee Lock
Figure 14. Saddle and knee locks.
Longitudinal Limit
Stops
Figure 15. Table limit stops and block.
Cross Limit Stops
Figure 16. Cross limit stops and block.
Model G0678 (Mfd. Since 06/15)
Saddle Lock
Limit Block
Limit Block
Advertisement
Table of Contents
