Headstock Turret Rotation - Grizzly G0695 Owner's Manual

Headstock Turret
Rotation
the turret rotates 360° around the column (see
figure 26).
figure 26. headstock turret rotated 45° to the
left.
Tools Needed
Wrench 19mm ................................................... 1
To rotate the turret:
1.
disConnECt miLL From poWEr!
Always lock the turret firmly in place after
adjusting the rotation. unexpected move-
ment of the head during operations could
cause the cutter to bind with the workpiece
causing damage to the cutter and workpiece,
and possible personal injury.
2. Loosen the three locking hex nuts on the tur-
ret (see figure 27).
-26-
figure 27. turret rotation locking hex nuts (2 of
turret
3.
Do not rotate the headstock past 50º right
or 50º left. If you do, you run the risk of
binding a turret bolt and the headstock
Qty
could jam.
4.
turret Locking hex nuts
(2 of 3)
3 shown).
rotate the head and turret around the column
to the left or right, and use the turret rotation
scale to determine the amount of rotation.
NOTICE
— if the headstock jams, remove the rear-
most turret locking hex nut. While swivel-
ing the exposed hex bolt back and forth,
rotate the column until the headstock freely
moves, then reinstall the locking hex nut.
Note: Swiveling the hex bolt head allows
the flats of the bolt head to re-align with the
T-slot.
re-tighten the three locking hex nuts to
secure the head and turret in place.
model g0695 (mfg. since 9/10)
turret
rotation
scale