Table of Contents
Advertisement
1. Screw one bracket to each end of the SmartController motion controller.
Use four of each of these connectors for each bracket:
M3x10 stainless socket-head cap screws
o
M3 high-collar split lock washers
o
M3 stainless flat washers
o
Tighten the M3 screws to 1.2 Nm (10.6 in-lbf).
There are two sets of two threaded holes on each side of the ventilation holes on the
sides of the SmartController case. See the following figure.
2. Screw the SmartVision MX industrial PC to the top of the brackets, using the mounting
tabs on the bottom of the SmartVision MX.
The SmartVision MX tabs go on top of the brackets.
Use two of each of these connectors at each bracket:
M4x8 stainless socket-head cap screws
o
M4 stainless split lock washers
o
M4 stainless flat washers
o
Tighten the M4 screws to 4.6 Nm (40.7 in-lbf).
Figure 3-3. SmartVision MX Mounted on a SmartController EX
SmartVision MX User's Guide, 14362-000 Rev. B
Chapter 3: Installation
Page 13 of 30
Advertisement
Table of Contents
