Step 3 Connect the USB cable
IMPORTANT
If the screen above is not displayed, installation of the MP Drivers or MP Toolbox is not
complete.
"Problems installing and uninstalling software"
1
Check that the machine is turned on.
2
Connect the USB cable to the machine and computer USB ports.
When you connect the USB cable to the computer, the machine is automatically detected, and the
computer performs the various settings. Wait a while as your computer performs the various settings.
Depending on your computer, a message may display asking you to restart your computer. If this is the
case, restart your computer. After restarting your computer, wait a while for your computer to continue
performing the various settings.
Install Utility Software
To install the Utility Software, in the [Setup] screen, click [Install Utility Software].
You can choose not to install the Utility Software at this stage and install it later.
View User's Manual
To read the manual on the CD-ROM, click [View User's Manual] on the [Setup] screen.
Installation is now complete. In the [Setup] screen, click [Exit] to close the screen. Then remove
the CD-ROM from the disk drive.
If installation fails before completion
Remove the software and reinstall it.
"Removing and reinstalling the software"
11