Honeywell NOTIFIER LDM Series Instruction Manual page 35

AIM-200 Point Annunciation
• Annunciator Address 2:
– Intelligent Detectors, addressed 1-64, on the AIM-200 installed next to the CPU-5000.
• Annunciator Address 3:
– Addressable Modules, addressed 1-64, on the AIM-200 installed next to the CPU-5000.
• Annunciator Address 4:
– Intelligent Detectors, addressed 65-96, followed by Addressable Modules, addressed 65-96, on the AIM-200 installed next to the
CPU-5000.
The System 5000 Programming Manual, Document 15584, provides programming instructions for this option. Refer to program choice
'AIM(256).
NOTE: AIM-200 detector and module addresses 97, 98 and 99 may be used, but cannot be point-annunciated.
Alarm and Trouble Mode without 8-Point Shift
Notes:
1) Circuit corresponds to a specific I/O module installed in user configured System 5000.
2) Without 8-Point Shift, the first 8 optional control switches correspond to CPU switch functions: ACK, RES,
NAC 1, NAC 2, MUN TIE, RELAY.
LDM Series Instruction Manual — P/N 15885:H3 8/12/2019
8 unusable
8 CPU
AIM-200
points
points
LDM Switch
LDM-32
Position
1 ACK
2 SIG.SIL.
3 RESET
4 not used
5 NAC 1
6 NAC 2
7 MUN TIE
8 Alarm Relay
9 Circuit 1
10 Circuit 2
11 Circuit 3
12 Circuit 4
13 Circuit 5
14 Circuit 6
15 Circuit 7
16 Circuit 8
Table B.3 LDM Switch Control Functions
48 points mapped to the
next six modules installed.
1st LDM-E32 2nd LDM-E32 3rd LDM-E32
Circuit 9 Circuit 25
Circuit 10 Circuit 26
Circuit 11 Circuit 27
Circuit 12 Circuit 28
Circuit 13 Circuit 29
Circuit 14 Circuit 30
Circuit 15 Circuit 31
Circuit 16 Circuit 32
Circuit 17 Circuit 33
Circuit 18 Circuit 34
Circuit 19 Circuit 35
Circuit 20 Circuit 36
Circuit 21 Circuit 37
Circuit 22 Circuit 38
Circuit 23 Circuit 39
Circuit 24 Circuit 40
System 5000 (UL 8th)
Circuit 41
Circuit 42
Circuit 43
Circuit 44
Circuit 45
Circuit 46
Circuit 47
Circuit 48
Circuit 49
Circuit 50
Circuit 51
Circuit 52
Circuit 53
Circuit 54
Circuit 55
Circuit 56
35