Loading Documents In The Adf; The Paper Path Of The Automatic Document Feeder - Canon imageCLASS D860 Basic Manual

Loading Documents in the ADF

Make sure there is no document on the
platen glass.
Fan the edges that will feed into the
machine first, then tap the edge of
multipage documents on a flat surface to
even the stack.
Adjust the slide guides to the width of the
document.
STMT
A5
LTR/
FLS/
A4
LGL

The Paper Path of the Automatic Document Feeder

• When documents are set in the ADF, the scanning unit moves to the position shown in the figure above
NOTE
and it is fixed there.
When a document is placed on the platen glass, the scanning unit moves to scan it.
3-4
The machine scans documents
from the last page.
Load the documents face down in the ADF.
D O C U M E N T R E A D Y
• The document is now ready for scanning.
• For a multipage document, the pages are
NOTE
fed one by one from the top of the stack
(from the last page).
• Wait until all pages of your document have
been scanned before starting a new job.
• 30 sheets of LTR-size (20 lb bond (80
g/m 2 )) documents can be set in the ADF. If
more than 30 sheets (LTR) of documents
are set in the ADF, paper jams may occur.
• 15 sheets of LGL-size (20 lb bond (80
g/m )) documents can be set in the ADF.
2
4
3
2
1
Scanning
unit