Power Cord; The Printer - Brother P-touch QL-650TD Setup & Operation Manual

10
Introduction

Power Cord

Follow the followings to avoid fire, damage, and electric shock.
Use only the authorized power source
(120VAC) for the printer.
Do not plug too many leads into a single
socket.
Do not damage or modify the power cord
or plug. Also, do not place furniture or
any heavy objects onto it, bend or pull it
by constraint.
Battery
Follow the followings to avoid liquid leakage, heat, rupture of the battery.
Use only the authorized battery for the
printer.
Do not throw into fire, heat up, or
disassemble the battery.
Store the battery where children cannot
reach. If you swallow the battery, contact
the doctor immediately.
If the liquid inside of the battery get into
your eyes, wash your eyes well with a lot
of clean water and then see the doctor
immediately.

The Printer

Follow the followings to avoid personal injury and damage of the printer.
The standard electrical outlet shall be installed near the printer and shall be easily
accessible.
Power Cord
Follow the followings to avoid personal injury and damage of the printer.
If the printer will not be used for an
extended period, remove the power
supply cord from the electrical outlet.
Warning
Do not use the power cord when it is
damaged.
Do not touch the power cord or plug with
wet hands.
Insert the power plug completely.
Do not insert the power cord into
dilapidated power outlet.
If the liquid inside of the battery adhere
to your skin or clothes, wash well with a
lot of clean water.
Do not connect both poles of the battery
with wire, keep the battery and metal
necklace and hairpin together to avoid
short-circuit of the battery.
Enclosed battery is not rechargeable.
Do not recharge it.
Caution
Always hold the power plug when
removing the power cord from or
inserting it into the outlet. Pulling on the
power cord could cause a problem with
the power cord.
Use only the power cord included with
the printer.