Connect The Power Cord; Load The Dk Roll - Brother QL-1100 Quick Setup Manual

3. Connect the Power Cord

Connect the AC Power Cord to the Label Printer. Then, plug
the AC Power Cord into a grounded AC power outlet.

4. Load the DK Roll

1.
Make sure that the Label Printer is turned Off.
2.
Pull the release levers on both sides of the Label Printer
to unlock the DK Roll Compartment Cover.
• Hold the Label Printer by the front, and firmly lift the
DK Roll Compartment Cover to open it.
IMPORTANT IMPORTANT
Before using the Label Printer, remove the protective
sheet (1) from the Label Output Slot.
3.
Place the DK Roll into the Roll Spool Guide (1).
• Make sure that the Roll Spool Arm (2) is inserted
firmly in the Roll Spool Guide.
• Make sure the Stabilizer (3) slides into the notch in the
Label Printer.
1
3
2
1