Replacing The Cutter Unit - Brother P-touch QL-650TD Setup & Operation Manual

56
STEP4 Maintenance and Troubleshooting

Replacing the cutter unit

Eventually the cutting blade on the cutter unit will become dull and need to be replaced.
At the appropriate time, purchase a new replacement cutter unit and install it according to
the following procedure. For purchasing a replacement cutter unit, refer to
User's Guide (PDF Manual)".
1
Check that the cutter unit is located to the home position.
2
Turn OFF the power to this printer and pull out the power cord from
the wall outlet.
3
Open the DK Roll cover and pull the roll
release lever to the up position. Remove the
DK Roll.
4
Using a Phillips-head screwdriver, loosen
the screw which holds the cutter blade unit
in-place.
The screw of cutter unit cannot be removed to
prevent the malfunction of the printer.
5
Hold the knob and carefully remove the
cutter unit.
Take care not to touch the blade of cutter.
6
Set the new cutter unit at the prescribed position.
"Software