Brother P-Touch 2450DX User Manual page 94

It is recommended that bar codes be printed with the Tape margin function set to FULL
and the bar code WIDTH parameter set to LARGE; otherwise, the bar codes may be dif-
ficult to read.
To use the Bar code function:
1 Rotate + until 14/21 BAR CODE is displayed, and then press + (OR hold down
c and press U once).
To change the data or parameters of a bar code that has already been created, position
the cursor below either half of the bar code mark (
21 BAR CODE and pressing + (OR holding down c and pressing U).
A block can only contain one bar code. If a bar code has already been entered in
the block when + is rotated to select 14/21 BAR CODE and + is pressed (OR
c is held down and U is pressed), the error message "1 BAR CODE PER
BLOCK!" appears.
To quit the Bar code function without making any changes, hold down c and
press U.
2 Type in the new bar code data or edit the old data.
To change the bar code parameter settings:
3 Press h.
To return to the bar code data without changing any parameter settings, press *.
4 Press f or w until the parameter that you wish to change appears.
5 Rotate + (OR press h or e) until the desired setting is displayed.
6 Repeat steps 4 and 5 until all parameters are set as you wish.
7 Press + (OR press r).
To add a special character to the bar code data:
8 Press f or w until the cursor is below the character immediately to the right of
where you wish to add the special character.
9 Hold down c and press s.
0 Rotate + (OR press h or e) until the desired special character is displayed.
The following special characters can only be entered when entering bar code types
CODE 39 or CODABAR.
90
Symbol Special character
1
2
) before rotating +
+
$
14/
to select