Brother P-Touch 2450DX User Manual page 25

On a Macintosh Computer
The Mac version of the software is for a Macintosh with an English operating system. If the
software is installed on a Macintosh with an operating system in a different language, the soft-
ware may not run properly.
BEFORE INSTALLATION
Check that your system configuration meets the following requirements.
Computer: Macintosh with Power PC processor
Operating system: Mac OS 8.6 to 9.X or OS X 10.1 to 10.2.4
Hard disk free space: At least 20 MB (100 MB for a full installation)
Up to 100 MB of hard disk free space may be needed when printing long labels or large
amounts of data.
Memory: At least 32 MB
USB port (installed as standard equipment)
CD-ROM drive
INSTALLING THE P-TOUCH EDITOR 3.2 SOFTWARE
The P-touch Editor 3.2 software includes a variety of more complex functions for printing bar
codes and images, enabling you to design just about any label you can imagine. Install the
P-touch Editor 3.2 software onto a Macintosh as described below.
With Mac OS 8.6 to 9.X:
1 With the P-touch and the Macintosh turned off, connect the P-touch to the computer
using the enclosed USB interface cable as described on page 6. Be sure to leave the
P-touch turned off.
2 Turn on the Macintosh.
3 Insert the enclosed CD-ROM into the computer's CD-ROM drive.
4 Double-click the Mac OS 9 folder to open it.
5 Double-click the P-touch Editor 3.2 folder to
open it.
21