Manually Lighting The - Cal Flame Chef C100 Owner's Manual

Lighting The Infrared or Rotisserie Burner
1. Open the hood.
2. Push in and turn counter clockwise the gas control knob for
the IR (infrared) burner to the HI position. This is the knob far-
thest to the left. On units with two IR burners, the control knob
for the right IR burner is the knob farthest to the right.
3. Rapidly rotate the rotary igniter knob next to the IR burner
knob. A multiple clicking noise should be heard from the ignit-
er indicating a spark is being provided to the burner.
4. If the burner does not light on the first try, repeat immediate-
ly.
5. If the burner does not light within 5 seconds, turn the control
knob to the OFF position. Wait 5 minutes until the gas clears
before attempting to light it again.
6. Repeat the procedure or try "Manual Lighting procedure" as
shown below.
7. Upon successful lighting, repeat the process on any other
available IR burner you may wish to light.
Wait 5 minutes before re-lighting a HOT rotisserie burner.
Manually Lighting The Infrared or Rotisserie Burner
1. Open the hood.
2. Push in and turn counter clockwise the gas control knob for
the IR (infrared) burner to the HI position.
3. Hold a lit match nest to the burner ports.
4. If the burner does not light within 5 seconds, turn the control
knob to the OFF position. Wait 5 minutes until the gas clears
before attempting to light it again.
5. If the burner does not light after several attempts see trou-
bleshooting guide on page 31.
6. Upon successful lighting, repeat the process on any other
available IR burner you may wish to light.
Wait 5 minutes before re-lighting a HOT rotisserie burner.
"Insert Cad
drawing
showing
burner control
knob"
"Insert Cad
drawing
showing
rotary igniter
knob"