Table of Contents
Advertisement
INSTALLATION OF YOUR NEW GRILL
Installing Access Doors
1. Provide cut out and door jamb with
inside dimensions as follows:
19 3/8" X 28 3/8" for DAD-30 and
19 3/8" X 40 3/8" for DAD-48
2. Check fitting of frame against cutout.
Mark location of rivet nuts.
3. Chisel material out to clear space for the
rivet nuts. (See figure 1)
4. Secure the steel frame with 16 screws of
type #10 X ¾ truss head phillips S/S.
5. Attach doors to frame.
(continued)
6. Adjust doors as follows:
a)
For height adjustment, loosen the
two screws attached to each
mounting plate.
(See figure A)
b)
Snap off hinge and secure mounting
plate with #6 X 1 flat phillips S/S.
(See figure B).
c)
For side adjustment turn screw to
increase or decrease door overlay.
(See figure C)
d)
For depth adjustment, loosen screw,
adjust door to desired position and
retighten screw.
(See figure D)
Advertisement
Table of Contents
