Multi-Conference - Sagem MC 300 Series Manual

You can then:
Initiate a new call
then:
Switch between the calls by
pressing OK.
Cancel the call on hold by pressing C.

7.8 Multi-conference

(Service depending on the operator and
depending on model)
If you have established a MULTI-
CONFERENCE, the screen displays
MULTIPARTY followed by the sequence
number assigned to each caller.
You can:
Cancel a call on hold or waiting by
pressing C.
Switch between the multi-conference call
and a call on hold or waiting by pressing
OK or make a further call.
7. Call services
MC300X_GB-07.p65
32
Make all the parties communicate by
Warning
pressing
persons: 5 in multi-conference and one
In this case,
separate call).
pressing ends
all calls.
Standard commands
Sequences of standard keys also permit access
to services such as call notification, call holding,
and open up additional possibilities:
0
1
1 X
2
32
* (A multi-conference is limited to 6
Reject a call holding or waiting (or
multi-conference calls).
End the current call holding or
waiting (or the multi-conference
calls if there are any) and accept
the call (or multi-conference calls).
End the current call order number
X.
Place on hold the current call (or
multi-conference calls) and accept
the call holding or waiting (or multi-
conference calls).
27/04/2001, 10:31