Installation Instructions - Moen 85900 Quick Start Manual

INSTALLATION INSTRUCTIONS

CAUTION:
Always turn water OFF before removing existing faucet or disassembling the valve. Open valve handles to relieve water
!
pressure and insure that complete water shut-off has been accomplished.
Before installing new faucet make sure that the cartridge nuts are in place. The cartridge and cartridge nuts were properly installed and tested
before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons
the cartridge nuts may not be properly installed. This should be carefully checked at time of installation. If the cartridge nuts are not properly
installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises could result.
1
14
15
1. Make sure that the mounting surface is clean and dry. Orient
deck gasket (15) as shown, then assemble the deck gasket to
the bar assembly, pushing the gasket around the mounting
shanks until it is seated inside the bottom lip of the
escutcheon (14).
3
4
5
6
3. Install lever handle (5) into handle hub (6). Be sure the O-ring
(4) is in place on insert.
Mounting Shank
2
2. From under the sink, thread mounting nut/washer (16) (large
side up) onto mounting shanks. Check faucet position on sink
top, and align and match escutcheon gasket to escutcheon,
then HAND-TIGHTEN. Connect supplies to mounting shank. If
using flexible supply lines, thread onto faucet supplies finger
tight, then tighten with a wrench by rotating one half turn.
16
2