Installation Instructions - Moen 4520 Manual

INSTALLATION INSTRUCTIONS

1
16
1. Be sure the mounting surface is
clean and dry.
With the supply lines (16)
connected to the faucet, drop the
faucet supply lines through the
deck.
1
3
4
6
7
16
13
1. Place plumber's putty (14) under seat (3).
2. Thread mounting nut (6), washer (5) and bottom gasket (4) onto
drain body (7). Wrap top threaded end of drain body with Teflon
tape (16).
3. Position drain body up through drain opening and screw seat onto
drain body.
4. Align the drain body so that the pivot rod opening faces the rear
of the sink and tighten the mounting nut snug.
5. Apply Teflon tape to the threaded end of tailpiece (13) and screw
into the drain body. Tighten firmly by hand.
6. Drop in drain plug (1) and install pivot rod in one of the following
ways:
(A) VANDALPROOF: Prevents unauthorized removal of drain plug.
Place pivot rod seat (8) into opening of drain body as shown. Place
2
2. From below the deck, assemble
the gasket (17), horseshoe (18)
and mounting nut (19) to the
mounting shank.
mounting nut
overtighten). Connect the inlet
supplies to the hot and cold
water supply lines. Turn on
water.
2
1 Drain Plug
2 Lift Rod & Knob
3 Seat
14 11
4 Bottom Gasket
5 Mounting Washer
10
6 Mounting Nut
5
7 Drain Body
8 Pivot Rod Seat
15
8
12
9
3
17
18
19
3. If supply tubes are bent, carefully straighten
each one using two hands. Thread supply line
nuts on finger tight, then holding one threaded
Tighten the fitting with a wrench, tighten nut with another
(do not wrench, rotating one half turn. Do not
overtighten. Make connections to existing hot
and cold stop valves. The hot supply tube is
always to the left when threaded shank is
positioned to rear. Turn on water.
CAUTION: Severe bends of the supply lines may
cause crimping and restricted water flow could
result.
9 Pivot Nut
10 Lift Rod Strap
11 Lift Rod Strap Screw
12 Spring Clip
13 Tailpiece
14 Plumber's Putty
15 Pivot Rod
16 Teflon Tape
the pivot rod (15) into the opening and position the pivot rod through
the drain plug hole as shown in illustration (A) above. Slide the pivot
nut (9) onto the pivot rod and thread it snugly onto the drain body, be
careful not to overtighten.
(B) EASY REMOVAL: For quick removal of drain plug for cleaning,
follow instructions above except position parts as shown in
illustration (B) above.
7. With lift rod (2) in position on the faucet, insert the end into the lift
rod strap (10) and secure with lift rod strap screw (11).
8. Connect the pivot rod (15) to lift rod strap using spring clip (12) as
shown above.
9. Place the drain plug in the full open position, loosen lift rod strap
screw and adjust the lift rod height so that the knob clears the
faucet. Tighten the lift rod strap screw. Installation is now
1
15
(A)
1
15
(B)
2