Replacing The Presser Foot; Presser Foot Precautions - Brother Innov-is 500D Operation Manual

SE-BrotherE_sgml.book Page 40 Monday, June 30, 2003 3:44 PM
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY

Replacing the Presser Foot

The presser foot presses down on the fabric.

Presser foot precautions

Be sure to observe the following precautions concerning the presser feet.
CAUTION
● Use the presser foot appropriate for the type of stitch that you wish to sew, otherwise the
needle may hit the presser foot, causing the needle to bend or break.
● Only use presser feet designed specifically for this sewing machine. Use of any other presser
foot may result in injuries or damage to the machine.

Replacing the presser foot

Replace the presser foot as described below.
Press (Needle position button) once or
twice to raise the needle.
Needle position button
• If the needle does not move when the needle
position button is pressed, an animation is
displayed on the LCD. Press the needle
position button after touching the LCD.
The needle is raised.
Turn off the sewing machine.
40
CAUTION
● Before replacing the presser foot, be sure
to turn off the sewing machine, otherwise
injuries may occur if the start/stop button
is accidentally pressed and the machine
starts sewing.
Raise the presser foot lever.
Presser foot lever
The presser foot is raised.
Press the black button at the back of the
presser foot holder.
Black button
Presser foot holder
The presser foot holder releases the presser
foot.