Chapter 7 Operation of Machine
5. Area Check
5-1 External Tracing
If
is pressed in other cases than "area over", the rectangular outline of the pattern is traced.
5-2 Automatic Hoop Movement in Area
0.1 mm
Embroidering area
• If "area over" is displayed, press
area, where the pattern is set, at the nearest position.
• After finishing the movement inside the area by this function, execute external tracing.
check that the needle and the presser foot do not interfere with the hoop before starting
embroidering.
• If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the
area. To enlarge the embroidering area, refer to Page 6-29 "Enbloidery Area".
7-6
(Example)
0.1 mm
.
Embroidering area
BE-0901E-AC-PC• BE-1201B-AC-PC
Embroidering
star position
The hoop automatically moves inside the embroidering
W1278Q
W1279Q
Then,
W1281Q