Maintenance And Inspection - Brother BE-0901E-AC-PC Instruction Manual

Maintenance and inspection of the sewing
machine should only be carried out by a
qualified technician.
Ask your Brother dealer or a qualified
electrician to carry out any maintenance and
inspection of the electrical system.
Turn off the power switch and disconnect the
power cable (do not pull on the cable itself)
from the wall outlet before attempting to
perform the following operations. Otherwise,
the machine is started if the start switch is
pressed by mistake. Injury may occur in
such a case.
• When carrying out inspection, adjustment,
or maintenance
• When replacing consumable parts such
as a rotary hook, a knife, or a fluorescent
lamp
4

Maintenance and inspection

BE-0901E-AC-PC• BE-1201B-AC-PC
If the power switch needs to be left on when
carrying out some adjustment, be extremely
careful to observe all safety precautions.
Use only the proper replacement parts as
specified by Brother.
When replacing a fluorescent lamp, use the
same-type lamp having a rating of 40 watts.
Wait until the fluorescent lamp cools off before
replacement. Failure to do so can result in
burns.
If any safety devices have been removed, be
absolutely sure to re-install them to their original
positions and check that they operate correctly
before using the machine.
Any problems in machine operation which result
from unauthorized modifications to the machine
will not be covered by the warranty.