Area Check; External Tracing; Automatic Hoop Movement In Area - Brother BE-1204B Instruction Manual

6. Area Check

6-1 External Tracing

If is pressed in other cases than "area over", the rectangular outline of the pattern is traced.
The outline of pattern can be checked in rectangle or octagon by setting "Checking embroidery area" in
"Environment 1".

6-2 Automatic Hoop Movement in Area

0.1 mm
Embroidering area
• If "area over" is displayed, press
area, where the pattern is set, at the nearest position.
• After finishing the movement inside the area by this function, execute external tracing.
check that the needle and the presser foot do not interfere with the hoop before starting
embroidering.
• If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the
area. Enlarge the embroidering area on the operation panel.
(Example)
0.1 mm
W1280Q
.
Embroidering area
BE-1204B-BC • BE-1206B-BC
Embroidering
star position
The hoop automatically moves inside the embroidering
Chapter 6 Operation of Machine
W1278Q
W1279Q
Then,
W1281Q
6-9