Brother HL-2060 User Manual page 16

USER'S GUIDE
Geräuschemission / Acoustic Noise Emission (For Germany
Only)
Wiring Information (For U.K. only)
xiv
Lpa < 70 dB (A) DIN 45635-19-01-KL2
If the mains plug supplied with this printer is not suitable for your socket
outlet, remove the plug from the mains cord and fit an appropriate three
pin plug. If the replacement plug is intended to take a fuse then fit the
same rating fuse as the original.
If a moulded plug is severed from the mains cord then it should be
destroyed because a plug with cut wires is dangerous if engaged in a live
socket outlet. Do not leave it where a child might find it!
In the event of replacing the plug fuse, fit a fuse approved by ASTA to
BS1362 with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE EARTHED
The wires in the mains cord are coloured in accordance with the
following code :
GREEN AND YELLOW
BLUE
BROWN
The colours of the wires in the mains lead of this printer may not
correspond with the coloured markings identifying the terminals in your
plug.
If you need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the
coloured insulation of the wires inside.
Cut each of the three wires to the appropriate length. If the construction
of the plug permits, leave the green and yellow wire longer than the
others so that, in the event that the cord is pulled out of the plug, the
green and yellow wire will be the last to disconnect.
Important
: EARTH
: NEUTRAL
: LIVE